Frost star snowflake hand embroidery pattern

Easy · 1 color · 2 kinds of stitch

Frost star snowflake: preview of the stitched design

A snowflake has a six-point star at its heart, cut like a gem by six lines from the middle knot to its notches: from each point of the star grows an arm with three pairs of side branches that shorten toward the tip. Every line is back stitch in navy thread, and one French knot marks the middle. One arm is repeated six times.

Size and details

Easy. Simple stitches in one color.

1 color of floss and 2 kinds of stitch, all of them line stitches and knots:

The stitched size, by hoop
Hoop	Inches	Centimeters
3 in (8 cm)	1.7 × 1.9 in	4.3 × 4.8 cm
4 in (10 cm)	2.5 × 2.9 in	6.4 × 7.4 cm
5 in (13 cm)	3.4 × 3.9 in	8.6 × 9.9 cm
6 in (15 cm)	4.2 × 4.8 in	10.7 × 12.2 cm
8 in (20 cm)	5.9 × 6.8 in	15 × 17.3 cm

In a 3 inch hoop the French knot is drawn smaller than about 2 mm (a little over 1/16 in). Use one strand of floss for it there, or choose a larger hoop.

The pattern is drawn inside a circle about half an inch (1.3 cm) smaller all around than the hoop.

What you need

DMC 336 Navy BlueSnowflake lines and center knot

The floss is six-strand cotton; the stitch guide says how many strands to use. You also need a hoop, an embroidery needle (a size 7 to 9 suits two or three strands) and plain cotton or linen fabric. To frame the piece in its hoop, cut a square 3 inches (8 cm) wider than the hoop: a 9 inch (23 cm) square for a 6 inch hoop.

Stitch guide

Back stitch 2 strandsSnowflake lines
French knot 2 strands, two wrapsCenter knot

Getting it onto your fabric

The PDF holds the pattern twice at actual size: once as drawn, and once mirrored for an iron-on transfer pen. Print it at 100% with scaling off and check the one-inch square (25.4 mm) with a ruler before you trace. How to transfer a pattern explains tracing, carbon paper and the other ways. The files are under Downloads.